英文版桌面壁挂非接触WIFI4G语音播报高温警告通道红外自动测温仪
1. 采用医学级工业测温探头，可以7*24小时不间断测温。
2. 采用精准的激光测距，将测距的探头与测温的平行，测温距离小于等于0.3米；
3. 检测速度：小于等于0.2秒。检测精度：±0.2摄氏度
4. 测温面板上增加了指示灯，让人可以做比较显性的配合，确定测温在什么距离一定能检测到的，指示灯正好就是35度0.3米的灯环；
5. 可测量人体手腕、额头、手掌等部位，快速测温；
6. 支持各国及各地方方言的自定义语音播报、高温警告；
7. 支持有线网络/WIFI/4G联网到防疫指挥中心平台及第三方平台；
8. 支持232/485/usb接口，支持各门禁机、第三方设备对接。
9. 可选支持人脸比对摄像机实现一人一档，可选支持两个开关量输出，体温正常一号输出，体温异常二号输出。
10. 安装灵活方便，低功耗，可通过移动电源实现移动式测温。
- 产品详情
- 产品规格
Product introduction6f彩票红8计划
Due to the new crown epidemic situation, public equipment should avoid contact cross infection as much as possible; this product uses non-contact medical grade special probes and precise laser ranging; unique dual sensors, advanced intelligent temperature measurement algorithm combining distance data, to achieve accurate palm temperature detection; efficient and fast temperature measurement;
Through the 7-inch visual terminal, built-in Android system, display the measured temperature value and voice broadcast. When the test temperature reaches or exceeds "37.30", it will display the temperature abnormality and send out the alarm sound;
The linkage on the temperature measurement panel, the normal temperature linkage blue light and the buzzer ring once, the opening signal is generally output when the No.1 relay is turned on, the red light and the buzzer ring continuously when the temperature is abnormal, and the alarm light and the alarm bell are generally output when the No.2 relay is turned on, because the upper logic such as Android system is not involved, the response speed is obviously much faster.To sum up, the speed can be 0.1s, but considering the continuous stability of temperature measurement results, it is recommended to set it to 0.2S.
Support networking function, and directly transmit data to emergency command center through wired network or 4G / WiFi network;
1、 Medical grade industrial temperature probe
With the probe imported from Germany, by distance of 5-15 cm it can reach the accuracyof 0.1-0.2 degree of medical grade.Industrial grade probe can work continuously for 24 hours, and there is no limit on the number of launches of the probe.One of the most important reasons why a consumer grade Potable Thermometer should be gun type is that the accuracy of the probe of the Potable Thermometer will gradually decline when it is used hundreds of thousands of times.The original forehead temperature gun is generally used in the home environment, and there is no effect on the weekly or monthly measurement.But for commercial occasions, the number of thousands of tests a day is basically not applicable.
2、 Man machine separation and self-service temperature measurement
The biggest problem of Potable Thermometer is one shot by one hand. If a confirmed person is detected, the gun holder is quite likely to be reinfected. Once he or she becomes asymptomatic, it may affect most of the people in a community, a school and become super communicators.We use fixed-point or mobile self-service temperature measurement points. The process of temperature measurement does not need close contact by security personnel, but only needs to show concern in the range of 15-30 meters. Only the abnormal personnel can handle it on site.
3、 Online big data early warning for epidemic prevention
